I have an old (1920’s) home constructed out of Rock Face block (Cinder). They are very porous, irregular and stained (rust, etc). They have never been painted and I would like to spray the paint on the home. What is the best product to use on this surface?

Help! I didn’t pay enough attention to drying time. The entryway door to our house is through the patio with a overhang of a second story bedroom. The porch light attracts small insects and the wooden wall gets dingy quickly (rest of house is vinyl sided. I power washed, filled

I have a new shed that I built about 4 months ago and I used exterior T-111 for the siding. I did not paint the T-111 right away like I should have. I now have the time to prime and paint it as needed but I noticed the sides are

I just recently painted my new fascia with a satin finish paint that has some gloss to it. I was told that paint with a bit of shine to it holds up better under the sun. With the dew and fog that we are having right now it is dripping

We are replacing some old warped and rotted trim boards. Should we paint and prime all sides before putting them up to help seal them in the event water gets behind them? Or is it sufficient to just prime the backs and then caulk them once attached?

I have pressure washed it and gotten all loose paint off. I have sealed the cracks in the stucco. I know I have to prime the repaired areas and the bear areas, but what about where there is still paint.