To provide the best experiences, we use technologies like cookies to store and/or access device information. Consenting to these technologies will allow us to process data such as browsing behavior or unique IDs on this site. Not consenting or withdrawing consent, may adversely affect certain features and functions.
The technical storage or access is strictly necessary for the legitimate purpose of enabling the use of a specific service explicitly requested by the subscriber or user, or for the sole purpose of carrying out the transmission of a communication over an electronic communications network.
The technical storage or access is necessary for the legitimate purpose of storing preferences that are not requested by the subscriber or user.
The technical storage or access that is used exclusively for statistical purposes.
The technical storage or access that is used exclusively for anonymous statistical purposes. Without a subpoena, voluntary compliance on the part of your Internet Service Provider, or additional records from a third party, information stored or retrieved for this purpose alone cannot usually be used to identify you.
The technical storage or access is required to create user profiles to send advertising, or to track the user on a website or across several websites for similar marketing purposes.
One Response
The ideal temp is around 75-80 degrees but it is possible to use most elastomeric coatings at higher temps.
1- Porous masonry surfaces can be pre-wetted by misting water to help extend the working time. Double check this with the manufacture. I have done this with a Sonneborn commercial elastomeric and Devflex. Don't saturate the surface, just mist prior to application.
2- At high temps rolling or brushing will be difficult. Don't over work the coating.
3- Work in the shade. Direct sun will only make the coating set faster.
Double check with the manufacture for additional recommendations.